Table of Contents
Advertisement
4.
RECORDING DIRECTLY
To make a recording, proceed as follows:
1
Insert a cassette. The video recorder will switch on
automatically. You can also switch it on by pressing
STOP/STANDBY h/m
button
2
To start the recording, press button
The word 'REC' and the current total recording time, e.g.:
3h, will appear in the display on the video recorder. The
video recorder will start recording.
3
Stop recording by pressing button
4
Select the total recording time with button
Some general tips:
* If you have forgotten to insert a cassette, the display
will read ‚NO CASSETTE'.
* If you accidentally try to start recording on a cassette
that is erase protected, the word 'PROTECTED' will
appear in the display.
The cassette will be automatically ejected.
* If the end of the cassette is reached during recording,
the appliance will stop automatically. If you have ac-
tivated repeat recording (REPEAT REC), the tape will
wind back to the beginning. The video will then start
recording at the beginning of the tape.
* Existing recordings on the tape will be automatically
deleted if you make a new recording on the tape.
.
REC. n
.
STOP/STANDBY h/m
TU
.
Erase protection
To prevent an important recording from being deleted ac-
cidentally, you can remove the erase protection tab on the
narrow side of the cassette with a screwdriver.
To undo the erase protection, seal the gap again with
adhesive tape.
.
11
Advertisement
Table of Contents
