Listen To Radio; Tune To A Radio Station; Program Radio Stations Automatically; Program Radio Stations Manually - Philips DC390/98 User Manual

5 Listen to radio

Note
‡
Only FM radio reception is available on this
unit.

Tune to a radio station

Note
‡
Position the antenna as far as possible from
TV, VCR or other radiation source.
‡
For optimal reception, fully extend and adjust
the position of the antenna.
1
Press TUNER to select FM tuner.
2
Press and hold
seconds.
» [SRCH] (search) is displayed.
» The radio tunes to a station with
strong reception automatically.
3
Repeat step 2 to tune to more stations.
‡ To tune to a weak station, press
UHSHDWHGO\ XQWLO \RX ÀQG RSWLPDO
reception.
Tip
‡ [STEREO] is default setting for tuner mode.
‡
Under tuner mode, you can press OK
repeatedly to toggle between [STEREO] and
[MONO], and the unit memorizes your setting
even if you turn off the unit or turn to other
sources.
/ for more than 2
/
Program radio stations
automatically
You can program a maximum of 20 preset
radio stations.
1
In the tuner mode, press and hold SET
TIME/PROG for more than 2 seconds to
activate automatic program mode.
» [AUTO] (auto) is displayed.
» The unit automatically stores radio
VWDWLRQV ZLWK VXIÀFLHQW VLJQDO VWUHQJWK
» 7KH ÀUVW SURJUDPPHG UDGLR VWDWLRQ LV
broadcast automatically.
Program radio stations
manually
You can program a maximum of 20 preset
radio stations.
1
Tune to a radio station.
2
Press SET TIME/PROG to activate the
program mode.
3
Press / to select a number.
4
Press SET TIME/PROG WR FRQÀUP
5
Repeat the above steps to program other
stations.
Tip
‡
To overwrite a programmed station, store
another station in its place.
‡ To select FM stereo or FM mono, press OK.

Select a preset radio station

1
Press / to select a preset number.
EN 15