Troubleshooting - Philips AZ113817 User Manual

XP AZ 1138/17 10-07-2001 18:42
If a fault occurs, first check the points listed below before taking the set for repair.
Do not open the set as there is a risk of electric shock. If you are unable to remedy a
problem by following these hints, consult your dealer or service center.
WARNING:
this will invalidate the warranty.
Problem
No sound/ power
Display does not function
properly/ No reaction to
operation of any of the controls Reconnect after a few seconds.
no d1SC, Cd Err or
nF d1SC indication/ MP3CD/
CD playback does not work
The disc skips tracks
Sound skips during
MP3 playback
Cannot find desired MP3 title
Poor cassette sound quality
Recording does not work
Pagina 17
Under no circumstances should you try to repair the set yourself, as
Solution
– Volume not adjusted. Adjust the VOLUME.
– Power cord not securely connected.
Connect AC power cord properly.
– Batteries dead /incorrectly inserted.
Insert (fresh) batteries correctly.
– Electrostatic discharge.
Switch off and unplug the set.
– No disc inserted. Insert a disc.
– Disc badly scratched/ dirty.
Replace/ clean disc (see maintenance).
– CD-R(W) is blank or the disc is not finalized.
Use a finalized CD-R(W).
– Laser lens steamed up.
Wait until lens has recovered to room temerature.
– Incompatible format used for MP3. Check if your disc
format is ISO 9960, Joliet, finalized multisession.
– Disc damaged or dirty. Replace or clean CD.
– Prog
SHUFFLE mode.
– MP3file made at compression level exceeding 320 kbps.
Use a lower compression level to record CD tracks
into MP3 format.
– Wrong file extension/ used.
Change file extension to .MP3
– Dust and dirt on the heads, etc.
Clean deck parts, see maintenance.
– Use of incompatible cassette types (METAL or
CHROME). Only use NORMAL (IEC I) for recording.
– Cassette tab(s) may be broken. Apply a piece of
adhesive tape over the missing tab space.

Troubleshooting

ram/ SHUFFLE is active. Quit program/
17