General Operating Instructions - Chicago Electric 40315 Owner's Manual & Safety Instructions

General Operating instructions

1. Fill Tray (17) with water and carefully slide
Tray under Blade. Make sure water level is
deep enough to cover lower edge of Cutting
Wheel Blade, but not so deep as to spill over
edge of Tray. (See Figure A, below.)
2. Pull up on the Lock Lever and slide the Rip
Fence (53) to set desired cutting width. Press the
Lock Lever down to lock Rip Fence in place.
3. If necessary, loosen Star Knob (20) and
tilt Table (51) to adjust angle of cut.
Retighten Star Knob.
4. Connect Power Cord/Plug (34) of Tile Saw to the
nearest 120 volt, grounded, electrical outlet.
5. put on anSi-approved safety glasses under
anSi-approved safety impact full face shield.
6. Fill water in Tray to proper level.
Turn Power Switch (21) on, and allow
Blade to spin up to full speed.
Table (51)
Power
Switch
(21)
Item 40315
Star Knob
(20)
Figure a
For technical questions, please call 1-888-866-5797.
7. Check to make sure Blade is picking up water from
Tray. If not, turn off Tile Saw. Unplug machine, and
refill Tray to appropriate level. Restart Tile Saw.
8. Place workpiece you are cutting firmly against Rip
Fence and slowly feed workpiece into Blade.
9. cautiOn! Keep hands and fingers away
from Blade. Also hold the workpiece you are
cutting firmly against Rip Fence throughout
cutting process. Failure to do so may
cause workpiece to be propelled by Blade
toward your body and/or into Saw.
10. Once cut is complete, turn Power Switch off.
Unplug Power Cord/Plug from its electrical
outlet. Allow Blade to stop on its own.
Then remove the workpiece and any
scrap material from the Table of Saw.
11. Remove and empty Tray of its contents,
and thoroughly rinse with clean,
cold water. Replace Tray.
12. Store Saw in a safe, clean, dry location out of
reach of children and other unauthorized people.
Lock Lever
Blade Guard
(49)
Rip Fence
(53)
Tray (17)
Page 11