Assembly - Husqvarna 545RX Workshop Manual

4
36
Centrifugal clutch

Assembly

Assemble the bearing in the clutch hou-
sing.
Fit the clutch drum to the drive axle.
Fit the clutch cover on the shaft.
505 69 85-70
Assembly
1. Heat the clutch housing to approx. 110
°C using a hot air gun.
2. Insert the bearing into position in the
clutch housing and fi t the circlip (G).
3. Slide the clutch drum into the ball
bearing.
4. Screw the drive axle tightly onto the
clutch drum.
5. Lubricate the drive axle with grease
and slide it on the shaft.
NOTE!
There should be no signs of grease
in the clamping joint for the shaft
and clutch cover.
Clean the surfaces using a
degreasing agent.
6. Screw the clutch cover tightly on the
shaft.