Assembly 535Fbx - Husqvarna 535FBX Operator's Manual

To assemble the engine to the frame
1. Assemble the engine and the frame with the bolt.
Make sure that the heel is put on the correct side of
the stop. Refer to the illustration.
2. Tighten the nut with the combination wrench to
approximately 15 Nm.
To assemble the load reducer
1. Attach the bottom part of the load reducer to the
frame.
2. Adjust the bottom part of the load reducer to a
correct work height. Tighten the knob.
3. Install the top part of the load reducer. Tighten the
knob.
10

Assembly 535FBX

To assemble the two-piece shaft
1. Turn the knob to loosen the coupling.
2. Align the tab of the cutting attachment (A) with the
arrow of the coupling (B).
3. Carefully push the shaft into the coupling until you
hear a click.
4. Tighten the knob fully.
B
A
1301 - 006 - 31.10.2022