Checking And Filling Oil Level - Caldertech 02-31-650 Operating Instructions Manual

Operating Instructions
04.
08
Hydraulic Squeeze Off Tool 180mm / 6" IPS / 200mm

Checking and Filling Oil Level

Fill Position
Squeeze tool frame in an upright,
squeeze bars fully open jack piston
completely retracted. These conditions
are necessary for checking and filling
the hydraulic oil level.
Note: Checking the oil level or filling
with the piston extended (squeeze
bars closed) or with the tool
horizontal can lead to overfilling,
this may severely limit the tool or
render the jack inoperative.
Checking Oil Level
Jack filler plug to be removed so oil
level is visible through the small hole.
If the oil level is lower than this hole or
not visible through the hole when the
squeeze tool is retracted and tool in
the upright position, then a top up may
be necessary.
Filling with Oil
In order to top up the oil, remove the
filler plug (as above) and fill with clean
hydraulic oil (type HL or HM 30cSt at
40 C) until the oil level is just below
0
the filler plug.
Replace the filler plug after filling.
04. Checking and Filling Oil Level
Filler Plug