Dolby Pro Logic - Philips FW775P/22 Instructions For Use Manual

CONTROLS
ª TEST TONE
– to check the sound level for Front Left, Front Right,
Center and Surround speakers respectively.
º MUTE
– to switch off the sound temporarily or to switch on
again.
⁄ DPL SOUND CONTROL
BALANCE +/- .... to balance the sound level of
the Front Right and Left
speakers.
CENTER +/- ....... to adjust the sound level of
the center speaker.
REAR +/- ............ to adjust the sound level of
the surround speakers.
¤ B
– to switch the system to standby mode.
Notes for remote control:
– First select the source you wish to control by pressing
one of the source select buttons on the remote control
(e.g. CD, TUNER, TAPE 1/2 or AUX).
– Then select the desired function (PLAY, NEXT, etc.).
10
pg 001-27/FW775-765P/22-Eng 10

DOLBY PRO LOGIC

Dolby Pro Logic
This state-of-the-art Dolby Pro Logic mini system enables
you to experience and enjoy a Home Cinema sound
ambience. The Pro Logic system allows more accurate
definition of the individual sound sources. It produces
greater sound separation between channels and provides
pinpoint sound localisation. Pro Logic provides four
outputs which are called Left, Center, Right and Surround
(Rear). Front signals are produced from the pair of Left
and Right speakers and a Center speaker. The surround
signal is reproduced by two speakers placed at the rear
of the listening area. Although the surround signal is
mono, a pair of speakers is necessary to produce the
correct diffused sound field.
This Pro Logic decoder enables you to decode the
following mode : Dolby Surround, Center Phantom,
Dolby 3 Stereo or normal Stereo .
Setting up the Dolby Pro Logic system
You need to do a proper set up in order for you to enjoy
the Home Cinema sound to the fullest. First you need to
do a complete speakers' connection.
5-Speakers Connection
• Front speakers : Connect the black wires to the black
FRONT terminals and the red wires to the red FRONT
terminals.
• Center speaker : Connect the black or non-marked
wires to the black CENTER terminal and the blue or
marked wires to the blue CENTER terminal.
• Rear (surround) speakers : Connect the black or
non-marked wires to the black REAR terminals and the
white or marked wires to the grey REAR terminals. You
may also connect a pair of wireless rear speakers (not
supplied) from the SURROUND OUT terminals.
CENTER
12 OHM
CENTER
REAR
SURROUND FRONT
REAR
LEFT
REAR
RIGHT
Positioning the Speakers
To get the best surround sound effect, place the speakers
as follow.
CENTER
MINI HIFI
SPEAKER
SYSTEM
FRONT
LEFT
TV
SURROUND
LEFT
9/1/99, 9:37 AM
FRONT
LEFT
FRONT
RIGHT
FRONT
RIGHT
SURROUND
RIGHT
3139 116 17601