Table Of Contents Introduction and Features Front and Rear Panel Layout Operating the S phantom Setting-up the S phantom Disconnecting the S phantom Typical Set-up Wiring Guide Specifications Copyright 2004, Samson Technologies Corp. Printed July 2004, v1.0 Samson Technologies Corp.
In this manual, you’ll find a more detailed description of the features of the S phantom, as well as a guided tour through the front and rear panels, step-by-step instructions for using the S phan- tom, and full specifications.
S phantom Front and Rear Panel Layout Front Panel Layout � � � MIC 1 INPUT- XLR balanced input for MIC 2 INPUT- XLR balanced input connecting condenser microphone. for connecting condenser micro- phone. 48V ON/OFF switch - When pressed in, the LED illuminates...
Operating the S Phantom Setting Up the S phantom The basic procedure for setting up and using your S phantom is simple and takes only a few minutes. Remove all packing materials (save them in case of need for future service) and check to make sure that you remove the supplied DC power adapter.
• Lower your master volume level control. • Now, power-down the S phantom supply by removing the AC adapter. Typical Set-up The following diagram shows a typical set-up for a project record- ing studio using the S phantom...
S phantom Wiring Guide Wiring Guide There are several ways to interface the S phantom, depending on your exact set-up. Follow the cable diagrams below for connecting your gear. �������� ���� ��� �� ������ ��� �������� ��� ����� ���� ��� �� �������� �� ����������...
5.65” L x 4.13” W x 2” H (144mm L x 105mm W x 51mm H) Weight 16.5 oz., 419 gm. Samson Engineering reserves the right to improve products from time to time, therefore, the specifications are subject to change without notice. Samson Technologies Corp.