Stop And Start Function - Renault MASTER User Manual

sToP anD sTarT fUncTion

This system enables a reduced fuel
consumption and lower greenhouse
gas emissions.
The system is activated automatically
when the vehicle is started.
While driving, the system stops the
engine (standby) when the vehicle is
at a standstill (traffic jam, traffic lights,
etc).
conditions for engine
standby
The vehicle has set off from where it
was parked;
for vehicles equipped with robo-
tised gearboxes:
– the gearbox is in position D, Mor N;
and
– the brake pedal is depressed (suffi-
ciently hard);
and
– the accelerator pedal is not de-
pressed;
and
– the speed is zero for around
1 second.
The engine remains in standby if N is
engaged with the parking brake applied
and the brake pedal released.
2.4
(1/3)
for vehicles equipped with manual
gearboxes:
– the gearbox is in neutral;
and
– the clutch pedal is released.

If warning light flashes, this
means that the clutch pedal is not suf-
ficiently released.
and
– the vehicle speed is less than ap-
proximately 2 mph (3 km/h).
The engine will restart when you press
the clutch pedal and move into gear.
for all vehicles:

Warning light on the instru-
ment panel is lit when the engine is on
standby.
The vehicle equipment remain opera-
tional while the engine is stopped.
If the engine stalls while the system
is in operation, pressing the clutch
pedal right down will start it again.
To fill up with fuel, the engine must
be stopped (and not put in standby):
you MUST stop the engine➥ 2.3.
If you get out of the vehicle, a beep
notifies you that the engine is on
standby and has not been switched
off.
Keep your vehicle station-
ary when the engine is
on standby (shown by the

warning light
instrument panel).
The engine MUST be
stopped (not put in standby)
before leaving the vehi-
cle.➥ 2.3.
on the