Preparations; Using The Remote Control; Setting The Clock - Philips MCM760/37B Owner's Manual

Using the remote control

IMPORTANT!
– Always point the remote control directly
towards IR area.
Notes for remote control:
– First select the source you wish to
control by pressing one of the source select
keys on the remote control (for example
CD, TUNER).
– Then select the desired function (for
example ÉÅ , 4 , ¢ ).
Inserting batteries into the remote
control
1
Open the battery compartment
2
Insert 2 batteries type R06 or AA into the
remote control with the correct polarity as
indicated by the "+" and "-" symbols inside
the battery compartment
3
Put back the compartment door
3
1
2
CAUTION!
– Remove batteries if they are
exhausted or will not be used for a long
time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances,
so they should be disposed of properly.

Setting the clock

After connecting MCM760 to the power supply,
set the clock first.
1
On the remote control, press and hold
DISPLAY/CLOCK until the clock time starts
flashing
➜
The display shows the set time
➜ 12:00 AM appears by default if you have not
set the clock
2
Press PROGRAM repeatedly to change
between 12-hour and 24-hour clock mode
3
Press à or á repeatedly to set the hour
4
Press É Å to change to minutes setting, then
press à or á repeatedly to set the minutes
5
Press DISPLAY/CLOCK again to store the
setting.
➜
The clock will start working.
Helpful hints:
– The clock setting will be erased when the system
is disconnected from the power supply.
– The set will exit from the clock setting mode if
no button is pressed within 90 seconds.
CD
REPEAT
TAPE A /B
TAPE REC USB REC
Preparation
STANDBY
TUNER TAPE AUX
PROGRAM SHUFFLE
DISPLAY/CLOCK
VOL
PRESET
ALBUM
USB DEL SNOOZE
17