Connections
IMPORTANT!
– The type plate is located at the
bottom of the system.
– Before connecting the AC power cord
to the wall outlet, ensure that all
other connections have been made.
– Never make or change any
connections with the power switched on.
Step 1: Placing speakers
Front
speaker
( left )
Place the front left and right speakers at equal
distances from the TV set and at an angle of
approximately 45 degrees from the listening
position.
Notes:
– To avoid magnetic interference, do not position
the front speakers too close to your TV set.
– Allow adequate ventilation around the DVD
System.
Step 2: Connecting speakers
Connect the speaker wires to the SPEAKERS
terminals, right speaker to "R" and left speaker to
"L", coloured (marked) wire to "+" and black
(unmarked) wire to "–". Fully insert the stripped
portion of the speaker wire into the terminal as
shown.
1
Speaker wire connection on main set
1
Speaker wire connection on speakers
8
Front
speaker
( right )
VIEWING AREA
2
2
Notes:
– Ensure that the speaker cables are correctly
connected. Improper connections may damage the
system due to short-circuit.
– For optimal sound performance, use the
supplied speakers.
– Do not connect more than one speaker to any
one pair of +/- speaker jacks.
– Do not connect speakers with an impedance
lower than the speakers supplied. Please refer to
the SPECIFICATIONS section of this manual.
Step 3: Connecting the control
cable
●
Connect the serial port marked CABLE at the
rear of the DVD player to the same por t at the
rear of the power amplifier with the supplied flat
control cable.
Step 4: Connecting TV
IMPORTANT!
– You only need to make one video
connection from the following options,
depending on the capabilities of your TV.
– Connect the DVD system directly to
the TV.
Using Composite Video jack
2
1
1
Use the supplied composite video cable (yellow)
to connect the DVD system's VIDEO jack to
the video input jack (or labeled as A/ V In, CVBS,
Composite or Baseband) on the TV.
2
To hear the TV channels through this DVD
system, use the audio cables (white/red) to
connect AUX IN jacks to the corresponding
AUDIO OUT jacks on the TV.