Correct Balance Of The Product; To Start A Cold Engine; Work Position - Husqvarna 545FR Operator's Manual

1. Fill half the quantity of gasoline in a clean container
for fuel.
2. Add the full quantity of oil.
3. Shake the fuel mixture.
4. Add the remaining quantity of gasoline to the
container.
5. Carefully shake the fuel mixture.
CAUTION: Do not mix fuel for more than 1
month at a time.
To fill the fuel tank
1. Clean the area around the fuel tank cap.
2. Shake the container and make sure that the fuel is
fully mixed.
3. Remove the fuel tank cap and fill the fuel tank.
4. Tighten the fuel tank cap carefully.
5. Move the product 3 m/10 ft or more away from the
refueling area and fuel source before you start the
engine.
Note: To see where the fuel tank is on your product,
Introduction on page 2 .
refer to

Work position

• Hold the product with 2 hands.
• Hold the product on the right side of your body.
• Keep the cutting attachment below waist level.
• Always keep the product attached to the harness.
• Keep body parts away from the hot surfaces.
• Keep body parts away from the cutting attachment.
1018 - 003 - 20.11.2019

Correct balance of the product

For forestry clearing, the product is correctly balanced
when it freely hangs horizontally from the suspension
point. With correct balance, the risk of hitting stones if
you release the handlebar is decreased.
For grass clearing, the product is correctly balanced
when the blade is at cutting height near the ground.

To start a cold engine

1. Pull the choke control (A) up.
2. Push the decompression valve (B).
Note: The decompression valve moves to the initial
position when the product starts.
3. Push the air purge bulb (C) about 6 times or fuel until
fuel starts to fill the bulb. It is not necessary to fill the
air bulb fully.
A
B
C
17