To Adjust The Balance Xt Harness - Husqvarna 545FR Operator's Manual

3. Tighten the hip strap tightly. Make sure that the hip
strap aligns with the hip.
4. Tighten the chest strap below your left arm tightly.
The chest strap must be tight against your body.
5. Adjust the shoulder strap until the weight is equal on
the 2 shoulders.
6. Adjust the height of the suspension point. For
forestry clearing, the correct height of the
suspension is approximately 10 cm below your hip.
Correct balance of the product on page 17 .
Refer to
7. It can be necessary to lower the suspension point
when you trim grass. If it is necessary, move the
suspension strap (A) to the lower suspension point
on the harness.
8. Tighten the elastic strap (B) to move the load from
the shoulders to the hip.
14
A
B

To adjust the Balance XT harness

Product overview on page 2 for an overview of
Refer to
the harness.
1. Stop the engine.
2. Push the safety-release mechanism down to release
the product from the harness.
3. To adjust the harness to the operator's height:
a) Push the spring loaded lock.
b) Turn the shoulder strap harness.
c) Move the shoulder strap harness to an applicable
hole on the back plate.
4. Attach the strap (A) in correct position for grass
clearing or forestry clearing.
5. Tighten the hip strap tightly. Make sure that the hip
strap aligns with the hip.
6. Push the 2 parts of the breastplate together as
shown.
7. Attach the side belt to the breastplate.
A
1018 - 003 - 20.11.2019