Husqvarna Automower 435X AWD Workshop Manual page 23

8. Remove the display from the display holder.
B
A
a) Push the display past the clips.
b) Lift the display.
9. Remove the display.
10. Install in opposite sequence.
5.3.13 To clean and replace ventilation filter for the
front unit
Note: The ventilation filter must be cleaned regulary and
must be replaced if it is damaged.
1. Remove the front top cover. Refer to
install the front top cover on page 13 .
2. Remove the front bumper tail. Refer to
and install the front bumper tail on page 14 .
3. Remove the front body. Refer to
install the front body on page 14 .
4. Remove the HMI lid. Refer to
the center console on page 17 .
1061 - 001 -
To remove and
To remove
To remove and
To remove and install
5. If the ventilation filter is not damaged.
a) Carefully clean the ventilation filter with a brush.
b) Install in opposite sequence.
6. If the ventilation filter is damaged.
a) Remove the ventilation filter.
b) Clean the mounting surface thoroughly.
c) Attach a new ventilation filter. Make sure that the
ventilation filter is fastened properly.
d) Install in opposite sequence.
5.3.14 To replace the sealing strips
There are 3 sealing strips in the product. The sealing
strips must be replaced using the same technique.
CAUTION: A 5 mm sealing strip must be used.
Sealing may be deficient if the wrong sealing
strip is used.
1. Start by laying one end of the sealing strip in line
with the marking on the chassis.
2. Continue laying the sealing strip clockwise around
the lower chassis.
3. Lay the other end of the sealing strip above the first
end and then out of the channel. Fasten the sealing
strip in the retainer.
Repair instructions - 23