Bosch B26FT Series Operating And Installation Instructions page 31

Problem
Water droplets are
forming on the exterior
of the appliance.
Water droplets are
forming inside the
appliance.
Drawers can only be
closed with great
difficulty.
Ice and water dispenser
Problem
The water filter symbol
is flashing.
The ice maker is not
making enough ice
cubes or the ice
cubes are deformed.
The ice maker is not
making enough ice
cubes or any ice
cubes at all.
The ice cube
container contains ice
cubes that are not
being dispensed.
Possible cause
Door will not close properly.
Humidity is too high.
Humidity is too high or doors have been
opened frequently.
The door seals are not tight.
The drawer has not been inserted
correctly.
The drawer rails are dirty.
Possible cause
The filter cartridge is old.
After replacing the filter cartridge, the
water filter symbol was not reset.
The appliance or ice maker was just
recently switched on.
A large amount of ice has been taken out.
Water pressure is too low.
The filter cartridge is clogged or old.
When switching from ice cubes to
crushed ice, an ice cube may become
jammed inside the dispenser opening.
The ice cube will begin to melt and water
will drip into the ice and water dispenser.
There is a layer of ice on the screw
conveyor.
Ice cubes are frozen to one another.
Corrective action
Align the appliance with a level. See "Aligning
the appliance".
Check the position of the drawers and
correct, if necessary.
Check the door seals and foldaway door bar;
if necessary, clean or correct position.
This may be normal in certain regions.
Do not open doors as frequently or do not
keep them open too long.
Check the door seals and foldaway door bar;
if necessary, clean or correct position.
Insert the drawer correctly.
Clean the drawer rails.
Corrective action
Replace the filter cartridge.
Reset the water filter symbol.
It takes approx. 24 hours before it starts
making ice.
It takes approx. 24 hours before the ice
storage bin is full again.
Have the water pressure checked.
Replace the filter cartridge.
Release the jammed ice cube from the
dispenser opening using a blunt plastic tool.
Do not use sharp or pointy objects as this
could damage the appliance.
Remove and clean the ice cube container.
Remove and clean the ice cube container.
en-us
31