Installation - IKEA DAGLIG Manual

ENGLISH
Problem
lights up on the timer
display.
If there is an error, first try to find a solution
to the problem yourself. If you cannot find a
solution to the problem yourself, contact
your IKEA store call centre. You can find a
full list of IKEA appointed contacts at the
end of this manual.

Installation

General information
Manufacturer is not responsible for any
injury to persons and pets or damage to
property caused by failure to comply
following requirements.
Caution! To proceed with the
installation refer to the assembly
instructions.
Warning! Installation process
must follow the laws, ordinances,
directives and standards
(electrical safety rules and
regulations, proper recycling in
accordance with the regulations,
etc.) in force in the country of use!
Warning! The appliance must be
earthed!
Possible cause
The second phase of the
power supply is missing.
• The electrical mains terminal is live.
• Make electrical mains terminal free of
• Loose and inappropriate plug and
• Have the clamping connections correctly
• Use strain relief clamp on cable.
• Follow the connection diagram (it is
Important!
• You must observe the minimum distances
Check if the appliance is
connected correctly to the
electrical supply. Remove
the fuse, wait for one minute,
and insert the fuse again. If
the problem continues, en-
sure a correct installation by
calling an authorised instal-
ler.
If you operated the appliance
wrongly, or the installation was
not carried out by a registered
engineer, the visit from the After
Sales Service technician or
dealer may not take place free
of charge, even during the
warranty period.
Warning! Risk of injury from
electrical current.
voltage.
socket connections can make the
terminal overheat.
installed.
located on the underneath surface of the
casting of the hob).
to other appliances and furniture
cabinets or other units according to
Assembly Instruction.
14
Remedy