Installing A Pc Server; Connecting An Additional Appliance; Mains - Philips MCW770/22B Custom Installation

Installing a PC server

See "Wireless PC Link Quick Installation".
Connecting an additional
appliance
It is possible to use an additional appliance,
e.g.TV,VCR or CD recorder with the set.
You can choose between high level input
sensitivity (e.g. for a connected TV or VCR)
and low level input sensitivity (e.g. for a
connected CD recorder).
1
Insert the red plug of a cinch cable to the
red socket AUX IN R and the white plug to
the white socket AUX IN L.
2
Connect the other end of the cinch cable
to the audio outputs of the additional
appliance.
3
Press SOURCE on the set repeatedly until
AUX is selected.
AUX: the high level input sensitivity for an
additional connected appliance is
selected.
To select the low level input sensitivity press
and hold for more than 2 seconds
SOURCE on the set until AUX CDR is
selected.
AUX CDR: the low level input sensitivity
for an additional connected appliance is
selected.
To toggle the input sensitivity press
SOURCE again for 2 seconds on the set.
or
Press AUX on the remote control
repeatedly until the desired input sensitivity
(AUX or AUX CDR) is displayed.
Note: It is not possible to connect a turntable
directly to AUX IN L/R. If you wish to use a
turntable, you have to connect an
RIAA-amplifier to AUX IN L/R on the set.
Then connect the turntable to the
RIAA-amplifier.

Mains

The type plate is located on the rear of
the set.
1
Check whether the mains voltage as shown
on the type plate corresponds to your local
mains voltage. If it does not, consult your
dealer or service organisation.
2
Make sure all connections have been
made before switching on the mains
supply.
3
Connect the mains cable supplied to
AC MAINS ~ and to the wall socket.This
switches on the mains supply.
When the mains cable is connected for the
0 0
first time to the wall socket TUNER and
AUTO INSTALL - PRESS PLAY is
displayed. Press either É Å on the set to
store all available radio stations
automatically (see also chapter "Storing
radio stations") or if you do not wish to
store them now press Ç on the set to
exit.
When the set is switched to standby, it is
still consuming some power. To disconnect
the set from the mains completely,
remove the mains plug from the wall
socket.
To avoid overheating of the set a safety
circuit has been built in.Therefore your
set may disconnect under extreme
conditions. If this happens, switch the
set off and let it cool down before
reusing it.
For users in the U.K.: please follow the
instructions on page 3.
Installation
15