Table of Contents
Advertisement
IMPORTANT SAFETY INFORMATION
System Requirements (Hot Water Tank, Filtration System and Tap):
• Do not install if water pressure exceeds 862 kPa. If your water
NOTICE
pressure exceeds 552 kPa, you must install a pressure limiting
valve. Contact a plumbing professional if you are uncertain how
to check your water pressure.
• Do not install where water hammer conditions may occur. If water hammer
conditions exist you must install a water hammer arrester. Contact a plumbing
professional if you are uncertain how to check for this condition.
• Where a backflow prevention device is installed on a water system, a device for
controlling pressure due to thermal expansion must be installed.
• Protect from freezing, shut off water supply, remove filter cartridge, drain hot
water tank and tubing when temperatures are expected to drop below 4.4° C;
see Seasonal Storage/Drainage section.
• Do not use a torch or other high temperature sources near system, cartridges,
plastic fittings or plastic plumbing.
• Do not install near water pipes which will be in path of a drilling tool when
selecting the position to mount the bracket.
• Mount system in such a position as to prevent it from being struck by other items
used in the area of installation.
• Ensure that the location and fasteners will support the weight of the system
when installed and full of water.
• Ensure all tubing and fittings are secure and free of leaks.
• Do not install using rigid piping. System intended for use with plastic water lines
(such as PEX tubing, PE tubing, PP tubing).
• Do not install this system if any of the quick connect collets are missing from
the filter head or Y-Quick Connector. Contact an authorised InSinkErator Service
agent if collets are missing from any fittings.
• For systems using two handle HC model taps, operate only one handle at a time.
• Important: Do not allow the unit to continuously boil.
• Regularly inspect the system. If there are signs of water leakage, turn off the
water supply and contact an authorised InSinkErator Service agent.
• A drain pan, plumbed to an appropriate drain or outfitted with a leak detector,
should be used in those applications where any leakage could cause property damage.
• For questions or concerns, please contact an authorised InSinkErator Service
agent (see back page for contact information).
Additional Consideration when Utilising Filtration System:
• The disposable filter cartridge MUST be replaced every 6 months, at the rated
capacity or sooner if a noticeable reduction in flow rate occurs.
• Failure to replace the disposable filter cartridge at recommended intervals may lead
to reduced filter performance and cracks in the filter housing, causing water leakage
or flooding.
• Protect from freezing, remove filter cartridge when temperatures are expected to
drop below 4.4°C.
• Do not install systems in areas where ambient temperatures may go above 43.3° C.
• Do not install in direct sunlight or outdoors.
• Flush filter for 4 minutes, 11.4 L before first use.
• Recommended water flow: 2.84 Lpm
WARRANTY INFORMATION
Taps:
Stainless Steel Tank:
Filtration System (excluding replaceable filtration cartridge):
This warranty is provided by InSinkErator, a business unit of Emerson Electric Co., ("InSinkErator" or "Manufacturer" or
"we" or "our" or "us") to the original consumer owner of the InSinkErator product with which this warranty is provided (the
"InSinkErator Product"), and any subsequent owner of the residence in which the Product was originally installed ("Customer"
or "you" or "your").
InSinkErator warrants to Customer that your InSinkErator Product will be free from defects in materials and workmanship, subject
to the exclusions described below, for the "Warranty Period", commencing on the later of: (a) the date your InSinkErator Product
is originally installed, (b) the date of purchase, or (c) the date of manufacture as identified by your InSinkErator Product serial
number. You will be required to show written documentation supporting (a) or (b). If you are unable to provide documentation
supporting either (a) or (b), the Warranty Period commencement date will be determined
by Manufacturer, in its sole and absolute discretion, based upon your InSinkErator Product serial number.
What is Covered
This warranty covers defects in materials or workmanship, subject to the exclusions below, in InSinkErator Products used by a
consumer Customer for residential use only, and includes all replacement parts and labor costs. YOUR SOLE AND EXCLUSIVE
REMEDY UNDER THIS LIMITED WARRANTY SHALL BE LIMITED TO REPAIR OR REPLACEMENT OF THE INSINKERATOR
PRODUCT.
What is not Covered
This limited warranty does not extend to and expressly excludes:
• Losses or damages or the inability to operate your InSinkErator Product resulting from conditions beyond the
Manufacturer's control including, without limitation, accident, alteration, misuse, abuse, neglect, negligence
(other than Manufacturer's), failure to install, maintain, assemble, or mount the InSinkErator Product in accordance
with Manufacturer's instructions or local electrical and plumbing codes.
• Wear and tear expected to occur during the normal course of use, including without limitation, cosmetic rust,
scratches, dents or comparable and reasonably expected losses or damages.
In addition to the above exclusions, this warranty does not apply to InSinkErator Products installed in a commercial or industrial
application.
No Other Express Warranty Applies
This warranty is the sole and exclusive warranty provided to the Customer identified above. No other express warranty, written or
verbal, applies. No employee, agent, dealer, or other person is authorized to alter this limited warranty or make
any other warranty on behalf of Manufacturer. The terms of this warranty shall not be modified by the Manufacturer, the original
owner, or their respective successors or assigns.
What we will do to Correct Problems
If your InSinkErator Product does not operate in accordance with the documentation provided to you, or you have questions
concerning your InSinkErator Product or how to determine when service is needed, please see attached Service Agency List.
The following information must be provided as part of your warranty claim: your name, address, phone number, your InSinkErator
Product model and serial number, and if necessary, upon request, written confirmation of either: (a) the date shown on your
installation receipt, or (b) the date shown on your purchase receipt.
Manufacturer or its authorized service representative will determine, in its sole and absolute discretion, if your InSinkErator
Product is covered under this warranty. You will be given the contact information for your closest authorized InSinkErator Service
Center. Please contact your InSinkErator Service Center directly to receive in home warranty repair or replacement service. Only
an authorized InSinkErator service representative may provide warranty service. InSinkErator is not responsible for warranty
claims arising from work performed on your InSinkErator Product by anyone other than an authorized InSinkErator service
representative.
If a covered claim is made during the Warranty Period, Manufacturer will, through its authorized service representative, either
repair or replace your InSinkErator Product. Cost of replacement parts or a new InSinkErator Product, and cost of labor for repair
or installation of the replacement InSinkErator Product are provided at no cost to you. Repair or replacement shall be determined
by Manufacturer or its authorized service representative in their sole discretion. All repair and replacement services will be
provided to you at your home. If Manufacturer determines that your InSinkErator Product must be replaced rather than repaired,
the warranty on the replacement InSinkErator Product will be limited to the unexpired term remaining in the original Warranty
Period.
Limitation of Liability
TO THE EXTENT PERMITTED BY LAW, IN NO EVENT SHALL MANUFACTURER OR ITS AUTHORIZED SERVICE
REPRESENTATIVES BE LIABLE FOR ANY INCIDENTAL, SPECIAL, INDIRECT, OR CONSEQUENTIAL DAMAGES, INCLUDING
ANY ECONOMIC LOSS, WHETHER RESULTING FROM NONPERFORMANCE, USE, MISUSE OR INABILITY TO USE THE
INSINKERATOR PRODUCT OR THE MANUFACTURER'S OR ITS AUTHORIZED SERVICE REPRESENTATIVE'S NEGLIGENCE.
MANUFACTURER SHALL NOT BE LIABLE FOR DAMAGES CAUSED BY DELAY IN PERFORMANCE AND IN NO EVENT,
REGARDLESS OF THE FORM OF THE CLAIM OR CAUSE OF ACTION (WHETHER BASED IN CONTRACT, INFRINGEMENT,
NEGLIGENCE, STRICT LIABILITY, OTHER SORT OR OTHERWISE), SHALL MANUFACTURER'S LIABILITY TO YOU EXCEED
THE PRICE PAID BY THE ORIGINAL OWNER FOR THE INSINKERATOR PRODUCT.
The term "consequential damages" shall include, but not be limited to, loss of anticipated profits, business interruption, loss of
use or revenue, cost of capital or loss or damage to property or equipment.
1-year warranty
1-year warranty
1-year warranty
Advertisement
Table of Contents
