Advertisement
(CC) compressor contactor as shown in the diagram. Refer to
Figure 4 if you have a single phase unit. Refer to Figure 5 if
you have a three phase unit.
NOTE: Connect both leads on the line side of the contactor.
(See Figures 4 (page 3) or 5 (page 4)
9.
Secure the crankcase heater leads with wire ties. Care must
be taken to ensure the leads do not come in contact with the
compressor discharge line, with any moving parts, or any sharp
edges.
10. Place the wiring diagram provided with the kit on the inside
of the Control Box access panel.
11. Reinstall the Compressor, Blower, and Control Box access
panels.
12. Reapply power to the unit.
13. The crankcase heater should immediately begin to heat. The
crankcase heater will heat at all times.
14. Reset the thermostat.
Insert Cartridge Heater
Fully into Tube under
Compressor. Secure with Spring
2
Compressor
Compartment
Compressor
Figure 2. BAYCCHT101AA (Reciprocating Compressor)
Hoop. Latch
hoop around
cartridge
End View
Figure 1. Cartridge Latching Spring
Blower
Compartment
Load
CC
Compressor
Contactor
Control Box
Compartment
Hook.
Connect
hook to end
of tube
Side View
Line
Advertisement
