Steam Components; Misting Nozzle - GE CleanSpeak GTD81ESPJMC Technical Service Manual

Misting Nozzle

The misting nozzle is located inside the dryer on the
left side of the rear bulkhead. The misting nozzle
it should not be cleaned. Replace a plugged or
restricted misting nozzle.
Misting Nozzle
To access the misting nozzle, it is necessary to
remove the drum. (See Drive Belt and Drum.) A 7/16
in. or 11 mm nut driver can be used to unscrew the
misting nozzle from the nozzle housing.
NOTE
replacement misting nozzle.

Steam Components

Nozzle Housing
– 37 –
To remove the misting nozzle connector and
housing:
1. Remove the misting nozzle. (See Misting Nozzle.)
2. For front service, tilt the top of the rear bulkhead
inward from the dryer frame. (See the Rear
Bulkhead section in this guide.)
3. For rear service, remove the back panel. (See the
Back Panel section in this guide.)
4. Press on the John Guest connector collar and
release the water line from the misting nozzle
connector.
5. Remove the Phillips head screw that attaches
the misting nozzle connector to the nozzle
housing.
6. Pull the misting nozzle connector out from the
nozzle housing.
Misting Nozzle
Connector
7. Remove the two Phillips head screws that attach
the nozzle housing to the rear bulkhead.
John Guest
Connector
Collar
Nozzle Housing