GE CleanSpeak GTD81ESPJMC Technical Service Manual page 11

G
My Settings
As the cycle selector knob is turned, the Time (Timed Dry), Level (Dryness Level), and Temp
(Temperature
setting, press the appropriate button(s). Then press and hold the My Settings button for 3
seconds. The status heart and button lights will turn on, and the dryer will save these settings
for that knob selection. In the future, when you turn the selector knob to that cycle, your
settings will be automatically recalled.
To temporarily (for this load) return to the pre-set default settings, depress the My Settings
change back to these defaults. To make these default settings permanent, hold the My
Settings button again for 3 seconds to make them your preferred settings (the lights will turn
back on).
NOTE: Variable Signal volume cannot be set for My Settings.
Variable Signal
Use the Variable Signal button to change the volume of the end of cycle and control signals.
NOTE:
• Remove garments promptly at the sound of signal. Place clothes on hangers so wrinkles
will not set in.
• Use the Variable Signal especially when drying fabrics like polyester, knits and permanent
press. These fabrics should be removed so wrinkles will not set in.
Drum Light
The drum light will go on if the Drum Light button is pushed or the door is opened. It will stay
on until the door is shut or the Drum Light or Power button is pushed.
Control Lock
You can lock the controls to prevent any selections from being made. Or you can lock the
controls after you have started a cycle. Children cannot accidentally start the dryer by
touching buttons with this option selected.
To lock the dryer controls, press and hold the Control Lock button for 3 seconds. The control
lock icon will light up when locked.
To unlock the dryer controls, press and hold the Control Lock button for 3 seconds.
NOTE: The Power button can still be used when the machine is locked.
H eDry
Available for Bulky Items,
Permanent Press, Active Wear, and Delicates. When the eDry button is pressed, cycle
settings change to reduce the total energy consumption of the selected sensor cycle.
NOTE: Cycle times will change when eDry is selected.
The eMonitor lights display the relative energy use of your selected cycle and options. They
are provided as an energy guide and range from Good (1 light) to Better (5 lights). Cycle (time),
dryness level, temperature, and additional tumble options can increase or decrease your
, Cottons,
– 11 –
, Jeans,