Table of Contents
Advertisement
PREPARATIONS
Power supply
Using the AC / DC adaptor
Turn off the player before connecting the supplied adapter to it and
the main power supply (as shown). The player must be turned off
when the battery charges.
✔
TIP
• The plug is a disconnect device and shall remain readily
operable.
• To avoid damage to the player, switch off before plugging
or unplugging the AC adaptor.
Using the car adapter
Connect the supplied car adapter to the set and the car cigarette lighter outlet.
✔
TIP
• To avoid damage to the player, switch off before plugging or unplugging
the car adaptor.
• When connecting with car power (cigarette lighter) adaptor, be sure the
input voltage of the adaptor is identical with car voltage.
• Make sure the temperature is below 35 o C when the DVD player is con-
nected to DC 16.0V in a car.
Powering your remote control
1
Open the battery compartment. Remove the protective
plastic tab (first time users only).
2
Insert 1 x lithium 3V battery, type CR2025, then close the
compartment.
CAUTION
-
Batteries contain chemical substances, so they should be disposed of properly.
-
Danger of explosion if battery is incorrectly replaced. Replace only with
the same or equivalent type.
-
Incorrect use of batteries can cause electrolyte leakage
and will corrode the compartment or cause the batteries to burst.
PREPARATIONS
-
Remove the battery if the remote control is not to be used for a long
time.
-
Perchlorate Material-special handling may apply. See
www.dtsc.ca.gov/hazardouswaste/perchlorate.
Connections
Connecting headphones
Connect the headphones into the
Connecting additional equipment
• Turn off your set before connecting to any additional equip-
ment.
• You can connect the player to a TV or an amplifier to enjoy
DVDs or karaoke.
AV OUT
Connect the desired device to this terminal directly (no setting needed in the DVD
mode).
White
Red
Yellow
p
jack of your set.
TV
Not supplied
AUDIO IN
VIDEO IN
11
Advertisement
Table of Contents
