4.
Configure the settings as explained in the following table:
Item
Description
MTU
Enter the MTU in bytes. The default setting is 1500 bytes.
Speed (Mbps)
Specify the interface speed. Because this setting does not determine the link speed, you
can specify any setting between 1 Mbps and the maximum speed that is supported by
the interface (either 1,000 Mbps or 10,000 Mbps).
Duplex
Select the duplex method from the drop-down list:
•
•
•
5.
Click Apply.
Configure the Virtual Network Interface Cards
By default, each physical Ethernet interface has one virtual NIC (VNIC) that has the following
configuration:
•
A generic label (default name) that is based on the number of the associated Ethernet
interface. For example, vnic0 is associated with eth0.
•
DHCP-enabled for IPv4
•
No VLAN membership
The default VNIC has the same numbering as the Ethernet interface that it is associated with
(eth0 has vnic0; eth1 has vnic1).
You can add multiple VNICs to each single physical Ethernet interface and channel interface.
ReadyDATA OS 1.2
Auto. The ReadyDATA 5200 autosenses the type of duplex connection.
Full. Full duplex. This is the default setting.
Half. Half duplex.
Configure the System Settings
52