Mounting Options - Cisco VCO/4K Mechanical Assemblies

To install the front door:
1. Grasp the sides of the door and position it so that the bottom is aligned with the studs
located at the base of the enclosure.
2. Flip up the two door latches located to the right and left of the lock. Hold the latches in
the open position and push the door toward the system enclosure until it snaps closed.
Press the door latches in.
3. Lock the door.
CAUTION: To ensure security, always lock the front door of the enclosure
after you have performed service procedures.

3.2 Mounting Options

The VCO/4K may be installed in an EIA standard cabinet that is 19 inches wide. If the VCO/4K
will be installed in a cabinet or rack, a mounting shelf must be secured to the cabinet/rack and
a mounting brace must be secured to the VCO/4K before it is lifted and placed in the cabinet
or rack. Figure 5 shows the mounting brace (one on each side) for the VCO/4K.
Refer to the Cisco VCO/4K Site Preparation Guide for specifications on the mounting brace
and shelf. Refer to the Cisco VCO/4K Installation Manual for information on attaching the
mounting brace and shelf.
Two rear support holes are located at the base of the each side panel. You have the option of
fabricating and attaching brackets for additional support when mounting the VCO/4K in a
cabinet or rack.
Figure 5: Mounting Brace
COMPONENT DESCRIPTION
System Enclosure 1-5