Table of Contents
Advertisement
COMMAND:
VALUES:
DEFAULT:
DESCRIPTION:
COMMAND:
VALUES:
DEFAULT:
DESCRIPTION:
COMMAND:
VALUES:
DEFAULT:
DESCRIPTION:
COMMAND:
VALUES:
DEFAULT:
DESCRIPTION:
COMMAND:
VALUES:
DEFAULT:
DESCRIPTION:
COMMAND:
VALUES:
DEFAULT:
DESCRIPTION:
COMMAND:
VALUES:
DEFAULT:
DESCRIPTION:
Chapter 4 - Modem Commands, S-Registers & Result Codes
Sr?
r = 0-11, 13, 15-17, 24-26, 29, 30, 32, 34, 36, 37, 48
n/a
Reads value of S-Register "r" and displays value in 3-digit
decimal format.
$SBn
n = speed
$SB115200 bps
$SB300 selects 300 bps at serial port.
$SB1200 selects 1200 bps at serial port.
$SB2400 selects 2400 bps at serial port.
$SB4800 selects 4800 bps at serial port.
$SB9600 selects 9600 bps at serial port.
$SB19200 selects 19,200 bps at serial port.
$SB38400 selects 38,400 bps at serial port
$SB57600 selects 57600 bps at serial port.
$SB115200 selects 115200 bps at serial port.
$SPn
n = 0 or 1
$SP0
$SP0 disables UUCP spoofing.
$SP1enables UUCP spoofing.
&SFn
n = 0 or 1
&SF0
&SF0 selects DSR follows CD.
&SF1 selects DSR independent.
&Sn
n = 0, 1 or 2
&S1
&S0 forces Data Set Ready On.
&S1 lets Data Set Ready act normally.
&S2 Data Set Ready drop is regulated by
S24 on disconnect.
T
n/a
Tone Dial
Modem will tone-dial numbers following the T.
&Tn
n = 4 or 5
&T5
&T4 selects Enable Response to Request for Remote Digital
Loopback.
&T5 selects Disable Response to Request for Remote Digital
Loopback.
39
Advertisement
Table of Contents
