Advertisement
INSTALL SPEAKER INTO HOUSING
1. Disconnect FAN MOTOR PLUG.
2. Partially install (2) #8-32 x 5/8 screws (Included in parts
bag - discard short screws and metal bracket) into threaded
holes in SPEAKER BRACKET - only so ends of screws are
flush with bottom surface of speaker bracket. Note: Installing
screws below flush will make the next couple of steps difficult.
FAN MOTOR
PLUG
#8-32 X 5/8"
SCREWS
SPEAKER
BRACKET
#8-32 X 5/8"
SCREWS
FAN MOTOR PLUG
3. Insert speaker into fan housing. Make sure SPEAKER
BRACKET hooks over edge of BRACKET OPENING.
4. Make sure rear surface of speaker is located as close to
wall of fan housing as possible.
5. Turn #8-32 X 5/8" SCREWS (partially installed in Step
2) until they make contact with FAN PARTITION PLATE.
Alternately tighten both screws. DO NOT OVERTIGHTEN.
NOTE: Screws are designed to raise and tighten speaker
bracket against motor bracket. Screw heads may or may
not contact speaker bracket when tight.
6. Insert SPEAKER PLUG into power receptacle where
motor plug was disconnected.
Connect FAN MOTOR PLUG into SPEAKER WIRE
7.
RECEPTACLE.
MODEL SPK110
Page 2
FAN PARTITION
PLATE
SPEAKER
BRACKET
BRACKET
OPENING
SPEAKER PLUG
SPEAKER WIRE
RECEPTACLE
Advertisement
