Table of Contents
Advertisement
Replacing bulbs:
Bulb for turn signal, parking, side
marker and standing lamp
(21/5 W/32/3 cp):
Loosen plastic nut (4) and remove
housing towards the front.
Turn bulb socket (7) with bulb coun
terclockwise and pull out. Push bulb
into socket, turn counterclockwise and
remove.
Bulb for high and low beam
(Halogen type 9004):
Compress cover (5) at the top and
remove upwards. Pull off electrical
connector (8). Turn clamping ring (9)
counterclockwise and pull out bulb
together with clamping ring. Remove
bulb.
Insert new bulb (flat side facing up),
mount clamping ring (9) (with tab
facing down) and turn clockwise. Push
electrical connector on securely.
Fog lamp bulb (Halogen type H3):
Compress the retaining clip of the
cover (6) at the top while removing it
upwards. Pull off electrical connector
(11). Disengage retaining clip and
remove bulb (10). When replacing
cover (6), make sure it clicks into
place.
86
Taillamp Assemblies
1
Side marker lamp
(10 W/6 cp bulb)
2
Turn signal lamp
(21 W/32 cp bulb)
3
Stop lamp (21 W/32 cp bulb)
4
Tail, parking and standing lamp
(10 W/6 cp bulb)
5
Backup lamp (21 W/32 cp bulb)
Turn both locks in the trunk to the left
as far as the stop and detach bulb
carrier. To replace the bulbs, depress,
turn t0
|eft and remove.
Hide quick links:
Advertisement
Table of Contents
