NAD C 375BEE Mounting Instructions

ASYNCHRONOUS USB DAC MODULE
®
Mounting Instructions
MOUNTING INSTRUCTIONS FOR THE C 375BEE
The DAC Module is compatible with C 375BEE. Using the supplied flexible flat
cable (FFC), DC power connector and screws, the DAC Module can be installed
in a C 375BEE by undertaking the following procedure.
STEP 1
Pre-install the requisite cables to their respective connector points on the DAC
Module as shown. Connect the FFC to the DAC Module's PP375 IN only if the
C375BEE has a PP375 already installed.
STEP 2
Make the following connections:
1 DC POWER connector from DAC Module to corresponding P216B in
C375BEE's main board.
2 FFC from DAC Module's ANALOG OUT to P213B on C375BEE's main board.
3 If the optional PP375 module is installed: FFC from DAC Module's PP375 IN
to the corresponding FPC (flexible printed circuit) connector of the PP375
module.
Ensure good harnessing by flexing and safely contorting the FFC and
DC POWER connectors.
STEP 3
Remove the dummy cover at the back of the C375BEE and install in its place the
DAC Module. Use the supplied screws to fix into place the DAC Module.
IMPORTANT!
The DAC module is only compatible with C 375BEE units that have the
0.5W standby logo on their rear panels.
Note that if the C 375BEE has a PP375 Phono Preamplifier Module already
installed, the DAC module and the PP375 can be linked together using the other
supplied FFC.
1
3
2