Philips HTS5553/98 User Manual page 20

6 Update software
Philips continually tries to improve its products.
To get the best features and support, update your
home theater with the latest software.
Compare the version of your current software
with the latest version on www.philips.com/
support. If the current version is lower than the
latest version available on the Philips support
website, upgrade your home theater with the
latest software.
Caution
•
Do not install a lower version of software than
the current version installed on your product.
Philips is not liable for problems caused due to
software downgrade.
Check software version
Check the version of the current software installed
on your home theater.
1
SETUP .
Press
2
Select [Preference Setup] and then press
OK .
3
Select [Version Info.] and then press OK .
» The software version is displayed.
EN
18
Update software through USB
What you need
•
A USB fl ash drive that is FAT-formatted, with
at least 75MB of memory. Do not use a USB
hard drive.
•
A computer with Internet access.
•
An archive utility that supports the ZIP fi le
format.
Step 1: Download the latest software
1
Connect a USB fl ash drive to your computer.
2
In your web browser, go to www.philips.com/
support.
3
At the Philips Support website, fi nd your
product and locate the Software and drivers .
» The software update is available as a zip
fi le.
4
Save the zip fi le in the root directory of your
USB fl ash drive.
5
Use the archive utility to extract the software
update fi le in the root directory.
6
Disconnect the USB fl ash drive from your
computer.
Step 2: Update the software
Caution
•
Do not switch off the home theater or remove
the USB fl ash drive during the update.
1
Connect the USB fl ash drive containing the
downloaded fi le to your home theater.
•
Make sure that the disc compartment is
closed and there is no disc inside.
2
Switch your TV to the correct source for
your home theater.
3
Follow the onscreen instructions to confi rm
the update.
» Once complete, the home theater
automatically switches off and restarts. If
it does not, disconnect the power cord
for a few seconds and then reconnect it.