Troubleshooting - HoMedics mybaby MYB-W10-CA Instruction Manual And Warranty Information

Press the CLEAN button and the unit will enter the auto cleaning mode. The motor will turn on and
pump for 30 seconds. During this period, you can press the CLEAN button again to abort the cleaning
function (motor will turn off). Repeat until there is no more soap in the reservoir. To thoroughly flush out
the unit, you should add water to the reservoir and repeat the cleaning process.
Note: Hold device over a sink or dish when running the Clean function,
to prevent soap from spilling onto counter.
IMPORTANT:
1. T he Motion Detector that activates dispensing uses a sensitive infrared sensor. To avoid
accidental dispensing of soap, please do not place the Soap Dispenser in direct sunlight.
2. A fter a period of inactivity, the soap inside Soap Dispenser may become dry and clog the line.
Should this occur, simply use a toothpick or water to remove the obstruction.
3. T he only part of the Soap Dispenser designed to be wet is the liquid reservoir and spout.
Do not immerse the Soap Dispenser in water as the product will be damaged.
4. R un the CLEAN Function to flush the liquid/soap reservoir with water and remove batteries from the
battery compartment whenever the Soap Dispenser is to be left unused for a long period of time.
5. T o clean the unit, use a soft damp cloth. Do not clean with a abrasive materials or corrosive substances.
6. T he device is not designed to be held or tipped upside down when there is soap in the Reservoir.
Use caution to maintain the device on a level surface at all times.
7. M ake sure your child understands that liquid soap solution is not for drinking and
that it should be kept away from the eyes.
Trouble Shooting:
No Soap Dispensed; Motor Does Not Run
1. E nsure that Soap Dispenser is turned on. Press and hold the POWER button for 3 seconds
to turn off. Press the POWER button once to turn ON.
2. Make sure hands are placed directly between the Motion Sensor and Spout.
3. E nsure that unit is not placed in bright sunlight, which will interfere with Motion Sensor operation.
4. Check that batteries are installed with correct polarity (+/–) and are not dead.
No Soap Dispensed; Motor Runs
1. D uring start-up you may need to activate the Motion Sensor several times to "prime" the pump
to begin dispensing soap.
2. The soap reservoir should be at least ¼ FULL.
3. M ake sure that no dried soap is clogging the spout or pump tubing.
Use a toothpick to clean the spout if necessary.
4