Cecilware FMP 403 HP-CE Manual page 5

Restraint must be reconnected after appliance has been returned to its originally installed position.
Installation of Quick Disconnect and High Strength Restrainer.
Set the length of the restraining device so that
the connector is not kinked when the
restraining device is fully extended.
Instructions for an appliance equipped with Casters:
1) The installation shall be made with a connector that complies with the Standard for Connectors for Movable
Gas Appliances, ANSI Z21.69 • CSA 6.16, and a Quick-Disconnect Device that complies to the Standard for
Quick-Disconnect Devices for use with Gas Fuel, ANSI Z21.41 • CSA 6.9.
2) Adequate means must be provided to limit the movement of the appliance without depending on the connector
and the Quick-Disconnect Device or its associated piping.
3) The location(s) where the restraining means may be attached to the appliance shall be specified.
ILLUSTRATION 1
1.
2.
3.
4.
5.
5
Restraining device should be installed parallel (in line) with the gas
appliance connector.
Attach the staple bracket (C) to a stud in the wall using the four 1" #12
screws (D) and the plastic anchors (E), if needed.
Locate a structural area (frame) on the rear side of the equipment that is in
line with the wall attachment. Drill a small hole, ¼" (per manufacturers'
recommendation). Please use caution when drilling hole, so that internal
components are not damaged.
Slide the hex nut (G) and a washer (I) onto the eye-bolt (F). Slide the eye-
bolt through the opening and place a washer (I) and the nylon lock nut (H)
onto the eye-bolt on the inside frame of the equipment and tighten down.
Attach one of the spring-loaded hooks (B) to the mounted bracket on the
wall (Step 2) and the other to the eye-bolt (Steps 3 and 4).
Note: For adjustable restraining devices, the cable is manufactured to be
shorter than the length of the gas connector.