Table of Contents
Advertisement
Tips
Tips
Care of the screen
Poor Picture
No Picture
Digital distortion
No sound
No solution found
for your picture or TV yourself. Check with your dealer or call a TV technician.
sound problem ?
Menu
Remote control
Standby
No stable or not
synchronised VGA
picture
Miscellaneous
20 20
Do not touch, push or rub or strike the screen with anything hard as this may
scratch, mar or damage the screen permanently. And please do not rub with dust
clothes with chemical treatment. Do not touch the surface with bare hands or
greasy cloth (some cosmetics are detrimental to the screen).
Unplug the TV before cleaning the screen.
When the surface becomes dusty, please wipe gently with absorbent cotton or
other soft materials like chamois soaks. Do not use acetone, toluene and alcohol
because they cause chemical damage. Do not use liquid cleaners or aerosol
cleaners.
Wipe off saliva or water drops as soon as possible.Their long time contact with
the screen causes deformations and colour fading.
• Have you selected the correct TV system in the manual installation menu?
• Is your TV or house aerial located too close to loudspeakers, non-earthed audio
equipment or neon lights, etc.?
• Mountains or high buildings can cause double pictures or ghost images.
Sometimes you can improve the picture quality by changing the direction of the
aerial.
• Is the picture or teletext unrecognisable? Check if you have entered the correct
frequency. See Installation, Manual installation, p. 6.
• Are brightness, sharpness and contrast out of adjustment? Select Factory settings in
the Setup, General menu, p. 8.
• Are the supplied cables connected properly ? (The aerial cable to the TV, the
other aerial to your recorder, the VGA cables to the display, the power cables.)
• Has the child lock been switched off ?
• Is your PC switched on ?
• Do you see a black screen and the indicator in front of the TV lights up green,
this means that the display mode is not supported. Switch your VGA-source to a
correct mode.
• In case of weak or bad signal, consult your dealer.
The low quality of some digital picture material may be the cause of digital image
distortion. In this case select the Soft setting using the Picture menu, Smart Picture,
without changing the picture settings manually.
• No sound on any channel? Check the volume isn't at minimum.
• Is the sound interrupted with the mute key
Switch your TV off and then on again once. Never attempt to repair a defective
Have you selected the wrong menu? Press the
menu.
• Check if the remote control is in the correct mode.
• If your TV no longer responds to the remote control, the batteries may be dead.
• You can still use the
Your TV consumes energy in the standby mode. Energy consumption contributes
to air and water pollution. Power consumption: 2 W.
Check if you have selected the correct VGA mode in your PC. See the separate
instruction manual with the monitor.
. Ambient temperature: + 5~ + 35°C
. Mains: 50/60 Hz Auto Voltage ranging from 198 V to 264 V
. Power consumption: around 160 W
. Standby consumption: 1 W
. Weight (excl. packaging): 17 kg
. Dimensions (wxhxd): 891x489x110
MENU/OK
key and the -/+ keys on top of your TV.
¬
?
MENU
key again to exit from the
Advertisement
Table of Contents
