LCD TV
Quick Use Guide
Thank you for purchasing this Philips LCD Television set. You are now the proud owner
of a LCD TV set which promises full value to you as a customer. Before you proceed to
install the LCD TV, please follow the steps and diagrams as shown to familiarise yourself
with the correct and safe way of assembling the stand to the TV.
A
SSEMBLING THE
1
3
1
2
For swivelling of the stand to function properly, adjust the swivel base at
the back of the stand until arrow is aligned in the center. Align the stand
studs into the holes at the bottom of the set. Put in the screws (provided)
into the 2 holes and tightened with a screwdriver.
CAUTION : While putting in the screws, hold onto the stand.
I
LCD TV
NSTALLING
If you intend to install the LCD TV on the wall. ensure you have the following :
– Standard VESA 100 bracket for LCD TV (not supplied) and four spacers found in the accessory bag.
Do the following when installing the LCD TV on the wall :
1
If your VESA bracket does not fit into the slot at
the rear of the LCD TV, proceed to make use of
the four spacers provided. Note : If VESA bracket
fits into the slot, you need not use the spacers.
S
TAND
!
Ensure you have the following before
you assemble the stand :
– Two screws (supplied with set)
– One Screwdriver (not supplied)
Place the set facing down on a protective
sheet close to the edge of a flat surface.
Bottom of swivel base
Align arrow
to the center
W
ON THE
ALL
2
VESA
Bracket
does not
fit
Screw the four spacers to the holes at the rear of
the set. Ensure the spacers are properly tightened
(torque of 1.2N-m or 1 lbf-in).
2
Open back plate cover by gently pulling upwards.
4
Close back plate cover by gently
pushing downwards.
Spacer
x 4
3139 125 33871
26PF8946
Check the stand arm is rigid and
properly installed. Place the
set upright.
3
Place the VESA bracket on the spacers and
tightened with the VESA bracket screws.
Tighten
VESA
bracket
to spacers