Cisco 7513 Series Manual page 27

The command show configuration displays the contents of the system configuration file stored in
NVRAM.
Router# show config
Using 1652 out of 130048 bytes
version 10.3(571)
!
hostname Router
!
enable-password guessagain
!
microcode TRIP flash trip1-0
microcode reload
!
interface hssi1/0
ip address 1.1.1.67
ip route-cache cbus
no keepalive
!
interface serial2/1
ip address 1.1.1.12
(display text omitted)
The command show protocols displays the global (system-wide) and interface-specific status of any
configured Level 3 protocol.
Router> show protocols
Global values:
Internet Protocol routing is enabled
Hssi1/0 is up, line protocol is up
(display text omitted)
Verifying the Installation Using show Command Descriptions and Examples
Cisco 7513 and Cisco 7576 Chassis Replacement and Upgrade Instructions 27