Utput; Onitor ) Connections - Philips 42TA2000/93 Quick Start Manual

The AV (Audio/Video) out jacks are great for
recording with a VCR or used to connect an
external audio system for better audio.
Disconnect all power sources before
making any connections.
For VCR Connection/Recorder:
1
Connect one end of the yellow Video Cable
to the VIDEO jack of AV OUT connection.
Connect the other end to the VIDEO IN jack on
the VCR.
2
Connect one end of the red and white Audio
Cable from the L and R AUDIO jack of AV OUT
connection to the AUDIO IN jack on the VCR.
3
Connect audio cable form the SPDIF jack on the
rear of the TV to the DIGITAL IN jack on the
rear of the hi-fi system.
Note: The SPDIF out is for digital audio output,
digital receiver, or amplifi er.
The SPDIF out supports PCM(plus width
modulate) format and stereo mode only when
the HDMI input source is selected.
4
Turn the VCR on, insert a blank VHS tape and
it's ready to record what's being viewed on the
TV screen.
Note: The Program recording is only possible
when the input signal is TV, AV1, AV2(Side).
This LCD TV can be used as a PC monitor. Your computer will
have to equipped with a VGA type video output and VGA cable.
1
Using a VGA cable (not supplied), connect PC's VGA OUT connector
to the VGA connector on the TV. Use the PC IN connections.
2
Using a MINI-JACK type AUDIO cable (not supplied), connect the
PC's AUDIO OUT connector to the AUDIO connector on the TV.
Use the PC IN connections.
3
Plug the power cable into AC inlet on LCD TV set. Plug the power
cable into an outlet and switch TV set on.
4
Use AV button on the remote control to select PC to use your LCD
TV as a PC monitor.
Note: Please refer to "Setting Up the PC Mode" section for all the
supported PC display modes. If possible, use the 1280 x 768@60Hz
video mode to obtain the best PC image quality.
AV O
PC (M
ONITOR

UTPUT

) C
ONNECTIONS
3
Wall outlet
1
2
8
2
VCR
:
A/CH
4
i + AV
Computer
3
1