Cable; Anual Sotre O Box ( With Rf I N /Outputs ); Box ( With Audio /Video Outputs ) - Philips 42TA2000/93 Quick Start Manual

1
Connect the Cable TV signal to the IN jack (or RF IN or CABLE
IN) on the Cable Box.
2
Connect an RF coaxial cable (not supplied) to the OUT jack (or
TO TV or RF OUT) of the Cable Box.
3
Connect the other end of the coaxial cable to the TV jack on the
LCD TV.
4
Plug the power cable into AC inlet on LCD TV set. Plug the
power cable into an outlet and switch TV set on.
5
Set the Channel 3/4 (or Output channel) switch of the Cable Box
to 3 or 4. Set the TV to the same channel. When watching TV
programming, change channels at the Cable Box, not the LCD TV.
H
ELPFUL
• Immediately after unpacking and plugging in your new television,
run the auto program function to set up the TV for the broadcast
or cable channels available in your area. If you do not run the auto
program function to set up the channels , your television may not
operate properly.
• Please make sure that you have selected the TV mode with AV key
on your remote control, before installing TV channels.
C
This connection will supply stereo sound to the LCD TV.
1
Connect the Cable TV signal to the IN jack (or RF IN or CABLE
IN) on the Cable Box.
2
Using a S-video cable (not supplied) connect one end of the video
cable to the Video Out jack of the Cable Box. Connect the other
end of the cable to the back of the TV.
3
Using RCA-type, stereo audio cables (not supplied), connect one
end of the cables to the left and right Audio Out jacks of the Cable
Box. Connect the other end of that cable to the Audio jack on the
back of the LCD TV. Audio cables are usually marked with red and
white and are available from Philips or electronics retailers. The
right audio jack is red and the left audio jack is white. Match the
cable colors to the jack colors.
4
Plug the power cable into AC inlet on LCD TV set. Plug the power
cable into an outlet and switch TV set on.
Note: Use the AV button on the remote control to tune to the AV channel
for the cable box signal. Once tuned, change channels at the cable box, not
the television.
When you watch programs using VCR, it's recommended to select Soft
Mode via Smart picture.
C B (
ABLE OX
H
INT
B (
ABLE OX WITH
RF I / O
WITH N
A / V
UDIO IDEO
6
):
UTPUTS
4
The Cable TV
signal from
Cable Company
1 2
OUTPUT
CH
3 4

CABLE

TO
IN TV
Cable Box
O ):
UTPUTS
4
Wall outlet
3
OUTPUT
CH
3 4
L
AUDIO
CABLE TO
1
OUT
IN TV
Cable Box
Cable TV signal
Wall outlet
3
�
75 coaxial cable
5
2
R
VIDEO
OUT
S VIDEO