Table of Contents
Advertisement
T6460/550/552EZ(EN)_EST.qx3
Specifications
Voltage: 220-240V/50Hz
Power consumption (Standby): less than 5W
Rewind time: less than 260 seconds
(cassette E-180)
Number of video heads: 2
Recording/playback time:
3 hours (SP) (cassette E-180)
6 hours (LP) (cassette E-180)
14PV135 14PV235
Power consumption: 52W
Dimensions in cm (HxWxD): 40.1x37.9x38.0
Weight without packing in kg: 10.5
1. Connecting the TV-Video Combi
Preparing the remote control for
operation
The remote control and its batteries are packed
separately in the original TV-Video Combi pack-
aging. You must install the batteries in the
remote control before use.
1.
1.
Take the remote control and the enclosed
batteries (2 batteries).
2.
2.
Open the remote control's battery compart-
ment and place the batteries in it as shown in
the picture and close the battery compart-
ment.
The remote control is now ready to use. Its
range is approximately 7 metres.
Connecting the cable
1.
1.
Insert the aerial
cable plug into
the AERIAL at
the back of the
TV-Video Combi.
2.
2.
Connect the
mains cable to
the wall socket.
3.
3.
If the little red standby light (STANDBY
the front panel of the set is not lit, please
switch on the set using the main power
switch. The power switch
left side panel of the set.
04.1.28
4:15 PM
Page 4
21PV385
Power consumption: 65W
Dimensions in cm (HxWxD): 51.2x51.0x49.5
Weight without packing in kg: 20.6
Supplied accessories
• Operating instructions
• Remote control and 2 batteries
4.
4.
Language setting picture will appear on the
screen.
I do not see a Language setting picture
• Check the cable connections.
You can find more details in chapter 'Preparation
for use'.
Connecting additional devices
You can connect addi-
tional devices such as
decoders, satellite
receivers, camcorders,
etc. to the EXT1/AV1
socket.
The respective scart socket is usually marked
'AV' or 'TV' on the decoder or satellite receiver.
Selection of the scart socket
• To select the Scart socket, please enter 0,0,1,
with the keys
appears on the screen.
) at
Selection of the front A/V sockets
• To select the front A/V sockets, please enter
0,0,2, with the keys
is located on the
'AV2' appears on the screen.
4
PUSH MENU TO CONTINUE
on the remote control. AV1
0..9
on the remote control.
0..9
EN
Advertisement
Table of Contents
