Table of Contents
Advertisement
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Metal Wall
Studs
Fig. 1
Holes Centered In
Metal Wall Studs
Fig. 2
!
While holding the plastic pull ring, slide the plastic retaining sleeve
towards the wall until it fits into the hole in the wall. This will hold
the toggle bolt in the wall while the Wall Bracket is mounted (refer
to Figure 4).
Push down on the lower plastic leg of the toggle bolt and break it off
9
flush with the wall (refer to Figure 5).
Push up on the upper plastic leg of the toggle bolt and break it off
10
flush with the wall (refer to Figure 6).
Install the remaining 3 toggle bolts in the remaining holes the same
11
way that the first one was installed.
12
Position the Wall Bracket in place and install the four 1/4-20 bolts,
including washers, in each of the outside corner holes. Do not
tighten completely (refer to Figure 7).
Confirm that the Wall Plate is level, then tighten the bolts securely
13
(refer to Figure 8).
Mounting to metal stud wall
&
Determine desired location to mount the Display Unit.
Within this area, locate the two 16.54" spaced metal wall studs that
must be used as the Wall Bracket mounting location.
é
Locate the center of both wall studs at the height that the Wall
Bracket is to be mounted.
"
With the Wall Bracket held in place, ensure it is properly leveled.
Then, mark where the four holes are to be drilled.
Note: Use only the four outside or end holes in the Bracket
(refer to Figure 1).
'
Remove the Wall Bracket and reconfirm that the marks made in the
previous step are located in the center of the metal wall studs. Re-
locate the marks as required to ensure that they are in the center of
the metal wall studs (refer to Figure 2).
3
Advertisement
Table of Contents
