Table of Contents
Advertisement
WASHER
Cavities In Block
Fig. 1
Fig. 2
Fig. 3
2
Mounting to concrete wall
&
Determine desired location to mount Display Unit. Use the enclosed
template for alignment purposes. (fig. 1)
é
With the Wall Bracket held in place, ensure it is properly leveled.
Then, mark where the four holes must be drilled. (fig. 4)
"
Remove the Wall Bracket, and using a 5/8" masonry drill bit, drill the
four holes. (fig. 2)
'
Insert a concrete anchor (with bolt) into each hole.
(
Firmly tighten each bolt.Then, remove the bolts.
§
Reposition the Wall Bracket, and with the four bolts (and washers),
secure into place.
Mounting to concrete block wall
&
Determine desired location to mount the Display Unit.
Within this area, position the Wall Bracket so that the four end
mounting holes are located over the cavities of the concrete blocks
(refer to Figure 1)
é
With the Wall Bracket held in place, ensure it is properly leveled.
Then, mark where the four holes are to be drilled.
Note: Use only the four outside or end holes in the Bracket.
"
Remove the Wall Bracket and reconfirm that the marks made in the
previous step are located in the cavities of the concrete blocks. Re-
locate the marks as required to ensure that they are in the cavities
of the concrete blocks.
'
With a 1/2" masonry drill bit, drill the four holes.
(
Hinge the plastic legs of the toggle bolt into the channel of the metal
end of the toggle bolt so it can fit into the 1/2" hole drilled in the
wall (refer to Figure 2).
§
Insert the toggle bolt into the hole in the wall and push it in until it
is in the cavity of the block.
è
With the plastic pull ring of the toggle bolt, pull the metal end of the
toggle bolt firmly against the back of the cavity of the concrete block
(refer to Figure 3).
Advertisement
Table of Contents
