Table of Contents
Advertisement
Other Configurations
The following configurations, like the panning orientation, would apply to your specific application need.
Maximum Pan/Tilt Travel
Once the CameraMan camera is installed, you can configure the maximum PAN/TILT settings to
the application. The camera has a maximum PAN range of 359°, but comes programmed with
factory default settings of ±90° of PAN and ±25° of TILT. If desired, use the following procedure
to change the maximum position settings:
1. Press and hold SETUP.
2. Press and hold one of the PAN/TILT arrows until achieving the desired maximum position.
3. Release SETUP.
4. Listen for two beeps to indicate that the maximum position for that direction has been set.
180° Default Pan Settings
359° Maximum Pan Settings
autoTRACK Windows
Each autoTRACK View includes a pre-programmed window. This window is an invisible area around the
presenter where the Tracking Ring's movement does not cause CameraMan to PAN or TILT. Once the
presenter moves in a direction outside of the invisible autoTRACK window, the CameraMan continues
to autoTRACK. This eliminates unnecessary camera motion, provides better picture quality for videotaping,
and minimizes the amount of updating necessary at lower CODEC update rates in videoconferencing
applications.
Each autoTRACK View has a preprogrammed window. Each window is set at a predetermined
factory default, and in most applications does not need to be adjusted.
Proper window sizes are factory-determined for best results. ParkerVision recommends that you
do not alter or adjust the window size.
If a change in Window size is absolutely necessary:
1. Press and release the desired autoTRACK View.
2. Press and release both SETUP and the desired SUBJECT POSITION arrow simultaneously
as follows:
Left Arrow
Right Arrow
Down Arrow
Up Arrow
3. Press and hold the selected autoTRACK View until you hear 2 beeps indicating that the new window
size has been set.
Page 12
CameraMan ® 3-CCD Presenter Camera System Installation and Operations Manual • © 2001 ParkerVision, Inc.
Before changing the autoTRACK Window size, you will need to power up the tracking ring package. Refer to page 13.
50° Default Tilt Settings
Decrease Pan Window
Increase Pan Window
Decrease Tilt Window
Increase Tilt Window
autoTRACK
View Buttons
Setup Button
Pan/TIlt Arrows
Invisible autoTRACK Window
Video Frame
Subject Position
Arrows
Setup Button
Advertisement
Table of Contents
