Advertisement
SET UP
1
1. Ensure the machine is on a
stable surface.
BEFORE YOU BIND
1
1. Select the correct comb diameter
using the comb storage tray.
STEPS TO BIND
1
Front
Cover
Back
Cover
1. Ensure edge guide is set to the proper
document size. Punch front and back
covers first.
CORRECTING A BOUND DOCUMENT
Additional sheets may be included or removed at any time by opening and
then closing the comb as previously described.
STORAGE
Lower the punch handle to the horizontal position. Lower the lid.
TROUBLESHOOTING
Problem
Punched holes are not central
Machine will not punch
Punch holes are not parallel to edge.
Partial holes
Damaged hole edges
Waste tray leaks
WARRANTY
Fellowes warrants all parts of the binder to be free of defects in material and workmanship for 2 years from
the date of purchase by the original consumer. If any part is found to be defective during warranty period,
your sole and exclusive remedy will be repair or replacement, at Fellowes' option and expense, of the defec-
tive part. This warranty does not apply in cases of abuse, mishandling or unauthorised repair. Any implied
warranty, including that of merchantability or fitness for particular purpose, is hereby limited in duration to
Australia Residents Only:
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable
loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. The benefits under Fellowes' Warranty are in
addition to other rights and remedies under a law in relation to the machine.
2
2. Check waste tray is empty and
correctly fitted.
2
2. Insert the plastic comb into
the mechanism.
2
30
Max 25
30
(80gsm)
(20 lb)
30
2. Punch sheets in small batches that
do not overload the machine or the
user. Adjust edge guide, if necessary.
Cause
Edge guide not set
Blockage
Debris is stuck below dies.
Sheets not correctly aligned to punch pattern.
Possibly overloading the machine
Waste tray is not correctly inserted or 'burst feature' has activated
3
3. Lift the lid. Ensure the comb-
opening lever is pushed backwards.
3
3. Pull comb-opening lever
forward to open the comb.
3
3. Load punched sheets directly
onto the opened comb. Starting
with the front of the document.
REMOVAL OF WASTE CLIPPINGS
The waste tray is located under the machine and is accessed from the right side. For
best results empty the tray regularly.
Solution
Adjust edge guide to correct paper or cover size.
Check waste tray is empty. Check for blockage to paper entry.
Take stiff cardboard and slide into the paper entry. Move the cardboard sideways
to release any stray clippings into the waste tray.
Adjust edge guide and test punch scrap sheets until correct
Punch plastic covers with paper sheets. Reduce number of sheets being punched.
Check waste tray is empty and 'burst feature' is closed.
the appropriate warranty period set forth above. In no event shall Fellowes be liable for any consequential
damages attributable to this product. This warranty gives you specific legal rights. You may have other legal
rights that vary from this warranty. The duration, terms and conditions of this warranty are valid worldwide,
except where different limitations, restrictions or conditions may be required by local law. For more details or
to obtain services under this warranty, please contact Fellowes or your dealer.
4
4. Lift the punch handle to its
upright position.
4
4. Test punch scrap sheets to check
edge guide setting.
4
4. When all punched sheets are loaded
onto the comb, push the comb lever
backwards to close the comb and
remove the bound document.
3
Advertisement
