Connecting Peripheral Equipment; Video Recorder; Other Equipment; Amplifier - Philips 21PT5401/12 User Manual

Connecting peripheral equipment

Connecting peripheral equipment
Depending on the models, the TV is equipped with either one or two scart connectors at the back of
the set, labelled as EXT 1 and EXT 2. The EXT1 connector has audio, CVBS/RGB input and audio,
CVBS output. The EXT2 connector (if available) has audio, CVBS/S-VHS input and audio, CVBS output.
Only EXT1 has built-in picture format auto detection. For EXT2, use the îÏ key on the remote
control to adjust the picture format.

Video recorder

VCR

Other equipment

Amplifier

(only available on certain versions)

Side Connections

4 5 6
7 8 9
0
Y ù
0
Carry out the connections shown opposite, using a good
quality euroconnector cable.
If your video recorder does not have a euroconnector socket, the
only connection possible is via the aerial cable.You will therefore
need to tune in your video recorder's test signal and assign it
EXT 2
EXT 1
programme number 0 (refer to manual store, p. 6).
To reproduce the video recorder picture, press
Video recorder with decoder
Connect the decoder to the second euroconnector socket
of the video recorder.You will then be able to record
scrambled transmissions.
Satellite receiver, decoder, CDV, games, etc.
For TV sets with 2 SCART connectors, preferably connect
the equipment delivering RGB signals (digital decoders, DVD
players, games consoles, etc.) to EXT1 and the equipment
EXT 2
delivering S-VHS signals (S-VHS and Hi-8 VCRs) to EXT2.
EXT 1
To connect to a hi-fi system, use an audio connection cable
and connect the "L" and "R" outputs on the TV set to the
"AUDIO IN" "L" and "R" input on your hi-fi amplifier.
EXT 2
L
EXT 1
R
Make the connections as shown opposite.
Headphones
When headphones are connected, the sound on the TV set will
be cut.The
The headphone impedance must be between 32 and 600 Ohms.

To select connected equipment

To select connected equipment
n
Press the key to select EXT1 and on the versions with 2 scarts,
Press the key to select EXT (and AV) for the side connections.
EXT2, S-VHS2 (S-VHS signals from the EXT2 socket) and AV for
Most equipment (decoder, video recorder) carries out the switching itself
the side connections (if available).
Most equipment (decoder, video recorder) carries out the switching itself.
@ #
P keys are used to adjust the volume level.
0 .
9