Sonance ASBPC6RS Quick Start Manual

S O N A N C E A R C H I T E C T U R A L S E R I E S
A.S. BANDPASS CONNECTOR QUICKSTART GUIDE
ASBPC3RS AND ASBPC6RS (ROUND AND SQUARE)
Box Contents
(1) Quickstart guide
(1) Bandpass connector
(1) Round grille
Remove the paint shield from the finished
mounting platform.
Remove sanding shield support structure. Use the
tether to guide the port tube through the back of
the mounting platform. Do not remove foam insert
from port tube yet.
1
3
Port Tube
Tether
(1) Square grille
(1) Hose clamp for port tube
(1) Grille painting instructions
(1) Set of speaker screws w/ Loctite
Cut the four tabs on the sanding shield
support structure on the bracket. NOTE: The
port tube tether is connected to the zip
tie for easy access.
Pull port tube down and expose all extra port tube
through speaker opening. Remove foam insert
from port tube. Cut and remove extra port tube
material, leaving 3 ribs or 1 5/8" (41mm) below
ceiling surface.
®
®
2
4