Table of Contents
Advertisement
5
Use your TV
Switching on
Follow the instructions on this page on how to switch on your TV set and the remote
control before going on to following pages describing how to use the channel set-up
procedure.
Switching off
To put the TV set into standby mode, press the
powered up, but with low energy consumption.
To switch off the TV set,
1. Insert two AAA batteries in the remote control.
Precautions on using batteries:
- Only use the battery types specified.
- Make sure you use the correct polarity.
- Do not mix new and used batteries.
- Do not use rechargeable batteries.
- Do not expose batteries to excessive heat such as sunshine, fire or
the like,
throw them in a fire, recharge them or try to open them, as
this could cause
- Remove the batteries from the remote control if you are not using it
for a long
period of time.
2. Connect the power cable to a mains socket. (If the power cable is not
connected
to the television, please first connect the power cable to the
television.)
Your TV set should only be connected to an AC supply. It must not be
connected to a DC supply. If the plug is detached from the cable, do
not, under any circumstances, connect it to a mains socket, as there is
a risk of electric shock.
Note: The figures are for representation only. The location of the power
socket at
the back of the television might differ depending on the model.
3. Connect the outside aerial or cable network to the ANTENNA IN socket
at the back of the TV set.
The aerial socket (75 OHM - VHF / UHF / cable) can be used for
connecting
an external aerial or other equipment fitted with a modulator
(video recorder,
connect other equipment
TV set to begin with, so as not to
the additional steps involved. Connect
setting up the channels.
4. Switch the TV on by pressing the power button.
Note:
The location and name of the power button on the TV may vary
according to TV model, at back side or bottom side of the back cabinets.
If the TV set is in standby mode, press the
control or the CH+/- buttons on the TV set to turn on the TV.
press the power button
.
them to leak or explode.
satellite receiver, etc.). We recommend that you do not
(video recorder, satellite receiver, etc.) to your
complicate the set-up procedure with
button on the remote control. The TV set remains
them when you have finished
button on the remote
8 EN
Advertisement
Table of Contents
