Connect A Dvd Player, Satellite Receiver Or Cable Box - Philips 37PFL7332/10 User Manual

10.8 Connect a DVD player, satellite
receiver or Cable Box
Connect the three separate component
1
video cables 1 to the YPbPr jacks on the
DVD player and to the Y, Pb and Pr jacks
of EXT3 on the TV.
Connect the audio cable 2 to the digital
2
out of the equipment and to the DIGITAL
AUDIO IN connector of the TV.
Select the equipment you have connected
3
in the Installation menu, 'Select your
connections', p. 26 and link it to EXT3.
Also select Digital audio in in the same
Connections menu.
In case of a DVD player with analogue
4
audio, connect the audio cable to the
DVD's audio L and R jacks and to the L/R
AUDIO jack of EXT3 3.
In case of a cable box and/or a satellite
5
receiver also connect the cable TV cable
and/or the satellite antenna cable 4 and
the aerial cable 5.
EXT3 :
AUDIO L/R
AUDIO IN
DIGITAL
EXT3 :
YPbPr
L R
1
AUDIO OUT
AUDIO OUT
(DIGITAL)
DIGITAL
AUDIO
IN
DVD
Notes
• cables are often colour coded. Connect red
to red, white to white, etc..;
• the labels for the component video sockets
may differ depending on the DVD player
connected. Although the abbreviations may
vary, the letters B and R stand for the blue
and red component signals, respectively,
and Y indicates the luminance signal. Refer
to the DVD player's instructions for use for
definitions and connection details;
• to get an optimal viewing, it is advised to
switch your equipment to the highest possible
supported display modes.
Warning
In case you notice scrolling images, wrong
colours or no colour, no picture, or even com-
binations of these on your screen, verify if the
connections are done in the correct way and
if the resolution and the signal standard of the
connected equipment are set in the right way.
See the handbook for your equipment.
EXT3 :
AUDIO L/R
CABLE
HDMI 1/2
75
HDMI 1 HDMI 2
5
4
EXT3 :
YPbPr
L R
1
AUDIO IN AUDIO OUT
AUDIO OUT
DIGITAL (DIGITAL)
DIGITAL
AUDIO
IN
SAT / STB
41