Connect Peripheral Equipment; Recorder (Vcr-Dvd+Rw); Other Equipment (Satellite Receiver, Decoder, Dvd, Games, Etc.); Side Connections - Philips 32PF9966/10 User Manual

Connect Peripheral Equipment

There is a wide range of audio and video equipment that can be connected to your TV.
The following connection diagrams show you how to connect them.
Note: can handle CVBS and RGB;
EXT1
and 480p, 576p, 720p, 1080i and 1152i.
It is preferable to connect peripherals with RGB output to
Note: If your recorder is provided with the EasyLink function, it should be connected to
Recorder ( - +
VCR DVD RW
Note: Do not place your recorder too close to the screen as some recorders may be susceptible to signals from the display. Keep a minimum
distance of 0,5 m from the screen.
CABLE
EXT2
1
2
3
4
RECORDER
Other equipment
(satellite receiver, decoder, DVD, games, etc.)
CABLE
CABLE
EXTERNAL
4
1
5
3
2
RECORDER

Side connections

2
1
3
CVBS, Y/C and RGB;
EXT2
or
EXT1 EXT2
)
Connect the aerial cables 1, 2 and, to obtain the optimum picture
quality, eurocable 3 as shown.
If your recorder does not have a euroconnector, the only possible
connection is via the aerial cable.You will therefore need to tune in your
recorder's test signal and assign it programme number 0 or store the test
signal under a programme number between 90 and 99, see Manual
installation, p. 6.
See the handbook of your recorder.
Decoder and Recorder
Connect a eurocable 4 to your decoder and to the special
euroconnector of your recorder. See also the recorder handbook. See
DECODER
Decoder, p. 10. You can also connect your decoder directly to
with a eurocable.
Connect the aerial cables 1, 2 and 3 as shown (only if your
&
peripheral has TV aerial in-/output).
Connect your equipment with a eurocable 4 or 5 to one of the
euroconnectors
é
Look for the test signal of your peripheral in the same way as you do for a
recorder.
"
Make a selection in the Setup, Source menu, p. 9.
Camera, Camcorder or Game
& Connect your camera, camcorder or Game as shown.
é Connect to
equipment also connect
AUDIO R
S-VHS quality with an S-VHS camcorder is obtained by connecting the S-
VHS cables with the
Do not connect cable 1 and 2 at the same time. This may cause picture
distortion !
Headphone
Insert the plug into the headphone socket L as shown.
&
Press ¬ on the remote control to switch off the internal loudspeakers of
é
the TV.
The headphone impedance must be between 8 and 4000 Ohm. The headphone
socket has a 3.5 mm jack.
In the Sound menu select
volume.
CVBS; can handle VGA, SVGA, XGA (not for 42PF9966)
EXT3 DVI
as RGB provides a better picture quality.
to benefit from the EasyLink functionality.
EXT2
, or to obtain a better picture quality.
EXT1 2 3
2 and
VIDEO AUDIO L
3.
input 1 and
S-VIDEO
Headphone volume
or
EXT1
3 for mono equipment. For stereo
inputs 3.
AUDIO
to adjust the headphone
2
19