Factory Default Menu Settings - Motorola OM 1000 Installation And Operation Manual

Factory Default Menu Settings

The power-up sequence configures the OM 1000 with the following factory default settings:
MAIN - CONTRAST = 6.
(MAIN menu contrast level is 6.)
INTFC 2 - DATA RATE = 9600
(Physical port 2 RS-232 I/O rear panel port is set to 9600 baud, asynchronous only.)
INTFC 6 - FREQ = 75.25 MHz, LEVEL = 35, MODE = OPERATE
(Physical port 6 frequency is set to 75.25 MHz, output level is 35, and in operate mode.)
PORT [01] – INTFC = 6/MOD, OUT, UNLCKD
(Logical port 1 RF modulator output port is enabled.)
PORT [02] - PID GEN, IN, UNLCKD,
PIDTBL Output Destination = 1
(Logical port 2 MPEG message generator is enabled as an input port and routed to logical
port 1.)
PORT [03] – INTFC = 3/ETHERNET, SRC-UDP = 5157, UNLCKD,
PIDTBL Output Destination = 1
(Logical port 3 Ethernet is enabled as an input port, source UDP 5157, and routed to logical
port 1.)
NET OAM&P - IP and SUBNET addresses set in BOOTP configuration
(OAM&P IP and subnet addresses are set in the BOOTP configuration.)
NET CTRL:HOST - NOHOST (IP address 0.0.0.0, set in OM1000.hst file)
(Host control status is set to no host in the OM1000.hst file.)
NET CTRL SVC - DAC2OM2 = 5167/tcp (set in OM1000.svc file)
(The DAC 6000-to-OM 1000 TCP/IP service connection is set to 5167 in the OM1000.svc
file.)
Setup and Operation
OM 1000 Installation and Operation Manual
4-3