Table of Contents
Advertisement
Section 2
TYPICAL MENU SCREEN AS IT APPEARS IN A COMMUNICATION PROGRAM
2.6
INSTALLATION MENU OPERATION WITH THE KEYPAD
This section describes how to use the KeyPad to access the Installation Menu. It will show you how to
navigate through its hierarchical structure and how to enter/edit site parameters. (Note that many of
these menu selections may be made prior to permanently installing the meter in the field.) Refer to
paragraph 2.2 Power Connections and Installation Drawing 1020-7 (or 1020DR-7) for wiring instruc-
tions before turning on unit.
2.6.1 ACCESSING AND LEAVING THE INSTALLATION MENU
When you first apply power to the meter, there will be a 20 to 30 second delay and then you will see a
scrolling banner and a copyright notice appear on the LCD panel display. This means that the meter
requires a new (or stored) site setup to be loaded into its active memory (active memory will be
explained later). The first time you access the Installation Menu, you can leave it only by saving a site or
by turning the meter off. After installing and activating a site, use the ENTER key to toggle between the
local flow display screen and the last accessed menu location.
To access the Installation Menu:
Make sure the Menu Lockout Switch is in the unlocked position (see paragraph 2.3).
Press the ENTER Key. This accesses the top level of the Installation Menu, as shown in the follow-
ing figure. Note that the top line of the LCD display shows the currently selected menu [Meter Type]
and that the second line shows [Single Channel] preceded by the "greater than" symbol (>).
Siemens
Siemens 1020
Copyright 2006
2-7
LCD Panel display
showing initial
screen with
copyright notice.
W ide B eam
Wide Beam
C lamp-O n
Clamp-On
Ultrasonic
U ltrasonic
Flowmeter
Flow meter
1020NFM-1D
Advertisement
Table of Contents
