Automatic Channel Installation - Philips Aurea 37PFL9903H/10 User Manual

Step 3: Select Antenna or Cable
This selection is only available when this TV is
prepared to receive DVB-C channels in your
country.
Select Antenna to install all digital terrestrial (DVB-
T) and analogue channels available.
Select Cable to install all digital cable (DVB-C) and
analogue channels available.
‡ Press o or œ to select Antenna or Cable.
® Press Next.
Ò If the TV asks for it, enter the Network ID you
received from your provider.
rNote
You can do a Channel installation if you are both
connected to a digital antenna and a cable network.
Therefore do the installation twice. To watch the
stored Antenna channels or the stored Cable
channels, you will have to switch between Antenna
or Cable in the Channel installation > Antenna or
Cable menu.
Step 4: Install TV and radio channels
Your TV will search for and store all available digital
and analogue TV channels and all available digital
radio channels.
If you selected Cable in Step 3, a Settings menu is
available. Leave these settings unchanged unless
your provider supplied specific values to use for
Network frequency, Network ID or Symbol rate.
Follow the text on screen to change the settings.
Use the digit keys to enter the numbers. You can
also select to install analogue channels or not.
‡ Select Start.
The installation may take a few minutes.
In case of Cable selection, the TV can ask to
enter the Network ID supplied by the cable
provider. Enter this ID with the digit keys.
® When the installation is done, press Finish to
return to the Channel installation menu.
Ò Press Menu Ï to quit the menu.
à Tip
When digital channels are found, the list of installed
channels may show some empty channel numbers.
If you want to rename, reorder or uninstall stored
channels, see section 6.3 Rearrange channels.
Channel installation
Step 5 Clock, time zone and daylight saving
selection
Only available when the country selected supports
digital broadcasts.
Go to a next step if this step is not applicable.
‡ Press œ to select Clock.
® Press π to enter.
Ò Press o or œ to select Auto clock mode.
† Press π to enter.
Installation Clock
... Auto clock mode
Connections assist. Time zone
Rename devices Daylight saving
Audio setup
Decoder
Man. network inst.
Clock
Factory settings
Auto clock mode
Select Automatic to instruct your TV to always get
the time correctly. Time zone and Daylight saving
correction are automatically set.
Select Manual when Universal Time Coordinated
(UTC) is not available in your area.
Time zone/Daylight saving
When you selected Auto clock mode manually,
select your local time zone and choose between
Standard (winter) and Daylight saving time
(summer).
33